香蕉视频91

Welcome to Qingdao Huicheng wood Equipment Co., Ltd! Hotline: 135-0532-3398
News Center
contact us

Qingdao Huicheng wood Equipment Co., Ltd

Mobile phone: 13505323398

Tel: 0532-89652000

Fax: 0532-87808277

Email: huichengshebei@163.com

Address: Jinling Industrial Park, Jihongtan, Chengyang District, Qingdao

In case of damage to sanding machine caused by improper operation
Time: June 29, 2019 22:07:50 Source: unknown Click: second
1、 Sanding machine must be operated by special personnel, and non professional personnel are forbidden to be used as sanding machine.
2、 Before starting up the sanding machine, it is necessary to check: 1) whether the voltage and air pressure are normal; 2) whether there are sundries in the machine; 3) whether the sanding belt is in good condition; 4) whether the oil level of the governor is normal; 5) whether the fastening screws of the sanding frame are tightened; 6) whether the infrared window and reflector are clean; 7) whether the belt of sanding motor is properly tensioned; 8) whether the dust collection is normal; 9) whether the grounding is good, Whether the lubricating oil of compressed air is sufficient.
3、 The sanding machine should be regularly oiled to lubricate the rotating and swinging parts.
 

 
4、 Before using the sanding machine, tension the belt and check whether it is normal and whether the installation direction of the belt is correct.
5、 Turn on the main power supply and check whether the brake disc is separated. It is strictly forbidden to lock and start.
6、 Before starting the main motor, check whether the sand rack swing is normal, start the main motors one by one, wait for the first main motor to operate normally, then start the second motor, and observe the sand belt swing when starting the main motor.
7、 Before feeding, measure the size of the workpiece with oil gauge caliper, and adjust the feeding height according to the measured data before sand test. The maximum sanding depth each time shall not exceed 0.5mm, and the width of sanding workpiece shall not exceed 1m.
8、 Sanding machine can only polish wood materials, and the workpiece can not contain metal, glass, sand and other hard and sharp materials.
9、 During sanding process, attention should be paid to the operation of the machine. In case of any abnormality, the machine must be shut down for inspection. In case of endangering personal safety, equipment safety, belt deviation, belt breakage and other emergency situations, the emergency brake switch must be used to stop the machine. The emergency brake switch should not be used when the machine is shut down under normal operation.
10、 It is forbidden to operate with gloves. Female workers with long hair must wear a hat and coil their hair in the hat.
11、 When operating the sanding machine, pay attention to it. Do not leave the machine. Do not touch the conveyor belt when the machine is running. Do not enter the machine by hand. Do not adjust the height of the sanding frame during operation.
12、 At the end of the work, the machine must be shut down according to the correct procedure, the dust inside and outside the machine should be cleaned up, all power supply and compressed air should be turned off, and the moisture in the air compressor and oil-water separator of sanding machine should be discharged.
Wechat customer service
Customer Service Hotline 135-0532-3398 Weekdays: 9:00 - 18:00 Consult immediately